Unboxing and Setting Up Your Promess.
Thank you for partnering with Promess on your application! In order to successfully get your system running there are a couple key points to pay attention to during the unpacking and setting up of your system. Please review the following videos for instructions.
Video Part 1
Unboxing your Promess Pt. 1 – Understanding the Promess Job Number
Share this video with your shipping team before unboxing
- Locate the Job Number in the job booklet
- Match UltraPRO controller, press, drive, and cables to the Job Number
- Confirm each components is organized to match the job number
Video Part 2
Unboxing your Promess Pt. 2 – Assembling Your Promess
- Unpack and organize components by assigned Job Number
- Match each UltraPRO controller with its corresponding cables, drives, and machinery
- Use labeled indicators (port names, device references) to connect cables correctly
- Verify all connections before powering on
Video 3
Maintaining your press
Promess systems are engineered for high reliability and low maintenance. However, to ensure optimal performance and extend system longevity, it is recommended to apply grease at intervals of every 250,000 cycles or every three months, whichever occurs first.
Recommended Grease: Kluber Isoflex NCA 15
Learn more about your Promess.
The USB credit card in your job packet will have manuals and software, but if you need additional information please reach out to Promess at 810-229-9334 or email us at [email protected].
