TORQUEPRO
Promess TorquePRO Systems are used by Builders and End Users in a broad range of functional torque testing and assembly applications. A few of these applications are listed below:
![]() |
Promess TorquePRO Systems are used by Builders and End Users in a broad range of functional torque testing and assembly applications. A few of these applications are listed below:
|
|
The first test is to measure the breakaway torque as the outer race is held and the inner race is turned. When the bearing is rotating, the average torque is measured over several rotations.
The resistance torque of the gear train is measured by driving and measuring the torque on the input shaft. Then the backlash throughout the gear travel is measured on the fly.
The first task in the process is to perform a break-in function by exercising the part through its full motion a predetermined number of times. After the break-in, the part is rotated through its full motion (one time) to measure the maximum and minimum torque values. The seat latch is then moved to the ship position.
The door hinge is first exercised in both directions and the peak torque is captured and stored. Then, based on the peak torque measured, the spring tension is adjusted to increase or decrease the amount of torque needed to rotate the hinge over the detent.